LiftMaster RSW12V Residential / Light Commercial Swing Gate Operator with Battery Backup - Manual (Page 3)

MISCELLANEOUS
DUAL GATE WIRING KIT
The dual gate wiring kit is 40 feet of interconnecting cable required for dual gate
applications.
Model MSWIRE12GA6C
OPEN
OPEN
CLOSE
SLEEP MODE
The operator enters sleep mode 10 seconds after the last command is given. The photoelectric sensor indicator LEDs
will not be on. The next command given will return the operator to normal operation.
REMOTE CONTROL
Once the remote control has been programmed operator will operate as follows:
When gate is in the closed position, activation of the remote control button will open the gate. During the open cycle
another activation of the remote control will stop the gate and the next activation of the remote control will close
the gate. When the gate is in the open position, activation of the remote control button will close the gate.
If a contact sensor detects an obstruction twice consecutively the alarm will sound
(up to 5 minutes) and the operator will need to be reset.
The gate does not meet
specifications.
Debris is on the gate's track
such as mud, rocks, dirt, etc.
(Slide Only) The gate has one or more
broken axles or wheels.
(Slide Only) The gate wheel is off the gate
rail. (Slide Only)
The gate is hitting a wall or
vehicle.
NOTE: In dual gate applications the reset switch/button must be toggled/pressed on the primary operator.
Remove any obstructions. Toggle/press the reset switch/button to shut off the alarm and reset the operator. After
the operator is reset, normal functions will resume.
When the inherent force of the operator (RPM/current
sensor) detects the following (twice consecutively) the
alarm will sound (up to 5 minutes) and the operator
will need to be reset:
REMOTE ANTENNA EXTENSION KIT
The remote antenna extension kit allows the antenna to be remotely installed.
Model 86LM
WIRELESS ACCESS CONTROL RECEIVER
Access control receiver for up to 450 Security✚ ® remote controls.
Model STAR450-315
HEATER
Keeps operator gearbox and batteries at suitable temperature when outside
temperature is below 0°F for extended periods of time.
Models HTRKITRSL (for Slide operator, includes bracket for optimal 7AH battery
location) and G6518SL (Slide replacement heater only)
Models HTRKITRSW (for Swing operator, includes bracket for optimal heater
location) and G6518CSW (Swing replacement heater only)
OPEN
OPEN
CLOSE
LOOP DETECTOR
Low power loop detectors.
Model LD7LP
OPEN
OPEN
CLOSE
MOUNTING STAND
For Model RSL Slide. Ideal to raise slide operator higher above the ground for snow
and other applications.
Model MSLM for Slide ONLY
OPEN
OPEN
CLOSE
Gate hinges are too tight or
broken and the gate is not
moving freely. (Swing Only) The gate is moving and a car
pushes the gate.
(Swing Only) A foreign object is on the gate
frame while the gate is moving.
(Swing Only) The gate hits the driveway, curb
or other, and gets stuck or bent
in an awkward position.
(Swing Only)
OPERATOR ALARM
The operator arm or gate is
incorrectly installed.
(Swing Only)
ACCESSORIES OPERATION
5 2
POST-MOUNTING PLATE
For post-mounting model RSW residential swing operator (also CSW200
commercial swing operator). Posts not included.
Model MPEL
for Swing ONLY
OPEN
OPEN
CLOSE