Staub Electronics WB-100-VPS WATTBOX - VERTICAL MOUNT POWER STRIP - Manual (Page 2)

IMPORTANT SAFETY INSTRUCTIONS
1. Follow, read, keep, and heed all instructions.
2. To reduce the risk of electric shock - Disconnect power to the receptacle before
installing or removing the unit.
3. Use only with standard, grounded electrical outlet.
4. DO NOT open or drill into any part of the housing. There are no user-serviceable
parts inside.
5. DO NOT plug in equipment that exceeds the amperage rating of the Power Strip.
(Amperage rating is shown on the product label) or the circuit breaker will trip.
If the circuit breaker trips, remove the overload from the Power Strip. Press the
“OFF” switch. Then return the switch to the “Reset” position.
6. The Power Strip is intended for indoor use only. Internal components are not
sealed from the environment.
7. Do not install the unit near water or where moisture is present.
8. Clean with a dry cloth.
9. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as when the power- supply cord
or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
10. To completely disconnect this equipment from AC power, disconnect the
power strip cord plug from the AC receptacle.
CONTENTS
INSTALLATION
RACK MOUNTING
1. Install the mounting brackets in the rack with the included hardware.
2. Align the Power Strip with the inside edge of the mounting bracket.
3. Apply pressure until the Power Strip “snaps” into place.
WALL MOUNTING
1. Draw a straight line where you want to mount the Power Strip
2. Using sheet rock screws (or other appropriate hardware),
attach the mounting brackets along the line where you
want the ends of the power strip.
3. Align the Power Strip with the inside edge
of the mounting bracket.
4. Apply pressure until the Power
Strip “snaps” into place.
For customer assistance call 1.866.838.5052
CLIP
(2) WB-100-VPS-6,
WB-100-VPS-8 &
WB-100-VPS-12
(3) WB-100-VPS-20
NUT
(2) WB-100-VPS-6,
WB-100-VPS-8 &
WB-100-VPS-12
(3) WB-100-VPS-20
SCREW
(2) WB-100-VPS-6,
WB-100-VPS-8 &
WB-100-VPS-12
(3) WB-100-VPS-20