Staub Electronics ES-SUB-EVO6-100 EPISODE - EVOLUTION 6 IN POWERED SUBWOOFER (100 WATT) - Manual (Page 5)

Page 5
ES-SUB-EVO-6 Owner’s Manual
© 2013 Episode
100-240V 50/60Hz
HIGH LEVEL INPUT
LFE
ES-SUB-EVO6-100
VOLUME
PHASE
AUTO
STATUS
OFF ON
R L
R L
1.6A
Designed and Engineered in USA
Manufactured in China
CROSSOVER
LOW LEVEL
0˚ 180˚
50
100
LFE
MIN MAX
AV Receiver/Processor
RCA Outputs
LS
RS
SUB
CEN
L
R
LR RR LF CF RF
Speaker Outputs
Left & Right
Preamp Out
LFE/
SUB Out
OR
WARNING! Do not connect to both the low-level RCA and high-level speaker
connections. Use only one connection method.
5. Making System Connections
5.1. Wiring Recommendations
• For line-level connections, use high-quality, low impedance RCA cables with adequate shielding and high-quality
connectors.
• Use two-conductor loudspeaker cable for high level connections that is appropriate for the installation environment
and wire length.
5.2. Audio Connections
To provide signal to the EVO subwoofer, a connection must be made from the audio source or speaker wiring. Most
home theater AV receivers and sources supply an “LFE” output for subwoofers that should be used if available. Stereo
line or speaker-level inputs from sources or speaker wiring may also be used.
CAUTION! DO NOT connect to both the line and speaker level connections at the same time. Use only line-level
connections, or only speaker-level connections.
5.2.1. Line-Level RCA Connections