Staub Electronics RL100 K40 - PORTABLE RADAR & LASER DETECTOR - Manual (Page 13)

For either option, here’s how to mute your device:
After pressing the MUTE button, the display will show
Mute On_
and the voice will announce “Mute On.”
NOTE: While this feature is engaged you will only receive
new alerts as visual indications on the display.
Speed Monitor
The Speed Monitor function alerts the driver when a pre-
selected speed is exceeded. The Speed Monitor can be set to
any speed between 40-100 mph in 5 mph increments.
When the preset speed is exceeded:
•
The RL100 emits a beeping alert tone accompanied by the
visual display blinking
Slow
then
Down
repeatedly.
•
The alerts will continue until the vehicle’s speed is reduced
to below the Speed Monitor setting.
The factory default setting for Speed Monitor is “Off.” To
access and turn on this function:
•
Press and hold FILTER button for 3 seconds.
•
Press and release MUTE button to select the desired
maximum speed for alerts.
•
5 seconds after your speed is selected, your setting will be
saved, the voice will announce “Exit” and your display
will return to the main screen.
13
Mute audio for Press and release
15 seconds or the MUTE button
duration of the alert
Mute audio for Press and hold MUTE
2 minutes or the button for 3 seconds
duration of the alert