System Sensor PDRP-2001 - Manual (Page 99)

PDRP-2001 Series Manual — P/N 53043:E1 2/28/2011 99
Read Status Operating Instructions
Pressing 1 allows the user to print the History file which will detail all of the system activities since
the file was last cleared from memory.
Pressing 2 allows the user to print the Walktest log which will detail all of the system activations
during walktest since the log was last cleared. Refer to “Walktest” on page 80 for additional
information on the display.
Pressing 3 will exit the Print operation.
4.15.11 ANN-BUS
Pressing 2 while viewing Read Status Screen #4 will display the settings for the ANN-BUS options
as shown in the following screens:
ANN-BUS Screen #1 indicates whether the ANN-BUS is enabled (Yes/No).
Pressing 1 while viewing ANN-BUS Screen #1 will display BUS Module addresses 1-8 and the
devices, if any, located at those addresses.
Pressing 2 while viewing ANN-BUS Screen #1 will display the programmed options for the ANN-
S/PG Module devices connected to the ANN-BUS.
Pressing 1 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
80 LCD annunciators connected to the ANN-BUS.
Pressing 2 while viewing ANN-BUS Screen #2 will display the programmed options for the ANN-
RLY devices connected to the ANN-BUS.
ANN-BUS
BUS ENABLED NO
1=BUS MODULES
2=ANN-S/PG OPTIONS
ANN-BUS
1=ANN-80 OPTION
2=ANN-RLY OPTIONS
ANN-BUS Screen #1
ANN-BUS Screen #2
NOTE: The ANN-I/O and ANN-LED modules do not require any additional
programming configuration.