Teledyne LeCroy PXD222 - Manual (Page 27)

Operation
PXD222-OM-E Rev A ISSUED: November 2001
23
Acquisition: The "Acquisition" indicator is green when data is being acquired and red when the
acquisition is stopped.
AutoSetup: The AutoSetup feature lets the digitizer display complex, unknown signals automati-
cally. This function optimizes the position, range, time base, and triggering.
Reset: The Reset feature will reset the PXD 222 Digitizer hardware and the software application
to a default state.
Hint: Typing values is easier that using the knob.
En CH1 and En CH2: The enable channel 1 and enable channel 2 buttons are used to turn on and
off channels 1 and 2 respectively. The color of the buttons matches the color of the trace.
CH1 and CH2 Probes: The BNC inputs to the digitizer do not include automatic probe sensing.
The CH1 and CH2 Probe switch should be set to 10 when a 10:1 probe is connected to the chan-
nel input, but it should be set to 1 when there is a direct connection.
V/Div. CH1 and CH2: Set the volts per division for each input independently by using the V/Div
knob or by typing a value in the V/Div control box. The V/Div knob will change color depending on
the channel selected: yellow when channel 1 is selected and red when channel 2 is selected.
These colors also match the trace colors in the graphic display.