Teledyne LeCroy WavePro 7 Zi_Zi-A - Manual (Page 23)

Getting Started Manual
922137-00 Rev A 15
signal meets the trigger conditions set for the type of trigger
selected. If the scope is already armed, it will force a trigger.

Stop - Press to prevent the scope from triggering on a signal. If you
boot up the instrument with the trigger in Stop mode, a no trace
available message is shown. Press the Trigger A
UTO
front panel
button to display your trace.
Horizontal Front Panel Controls
Note: Horizontal front panel controls correspond with screen menu
selection: Timebase → Horizontal Setup....

Delay - Press to toggle between a zero horizontal delay value and
the previous horizontal delay value. Turn to change the horizontal
delay value.

Time/Div - Turn to set the time/division of the oscilloscope timebase
(acquisition system).