Teledyne LeCroy ZS4000 - Manual (Page 10)

ZS4000 High-Impedance, Active Probe
4 923360-00 Rev A
Tips
Straight Tip The straight tip is rugged and designed for
general probing. Fits in either probe socket.
IC Lead Tip The IC Lead Tip is covered in insulation on all
sides (except for a small edge), this tip was
designed to prevent shorting neighboring IC
leads. The gold part of the tip is not insulated
and should touch the IC lead to be tested. It is
one-size-fits-all and will work with any IC lead
pitch. Fits in either probe socket.
Bent Tip The Bent Tip is made out of titanium, this tip is
ideal for situations that require you to hold the
probe parallel to the circuit board under test.
Also gives you more control when holding the
probe like a pencil. Fits in either probe socket.
Pogo Tip The pogo tip provides z-axis compliance. The tip
can fit into a socket or onto an IC leg.
Right-Angle Socket The Right Angle Socket allows the probe to be
connected to a pin on the board under test,
while keeping the probe parallel to the board.