Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 50)

48
Teledyne LeCroy System Control Ribbon ‐ Main Tab
Figure 6.1: Master Controls Panel
Note: The difference between Start (don’t record) and Start (record results) is that while running (but
not recording results) the system allows the user to change any of the signal or jitter settings
while a test is running. This is useful during initial test development to quickly determine how
the device under test behaves under different conditions. If results are being recorded, the user
may not change test settings without first stopping the test.
PeRT
3
Selection
The PeRT
3
Selection panel allows the user to specify which PeRT
3
system is to be
controlled by this application by selecting either the local host machine or a remote host
machine. When the host machine is selected from the drop‐down menu, information
about the hardware associated with that system is shown in the fields below the system
name. In addition, this allows the user to specify the number of channels to be tested (up
to the maximum number supported by the hardware configuration).
Figure 6.2: PeRT
3
Selection Panel