Teledyne LeCroy PeRT3 Phoenix System - Manual (Page 57)

Teledyne LeCroy PeRT
3
Phoenix System User Manual 55
System Control Ribbon ‐‐ Channel Tabs Teledyne LeCroy
Figure 6.12: Using the Arrow
Once a range has been defined, click outside the range box and the slider bar will now
display the defined range as shown below. The minimum and maximum values are
indicated and the direction of change is shown by the arrow.
Figure 6.13: Defined range
If custom steps are desired, click the Custom Steps box and type in the values desired, in
any sequence desired, separated by commas. For example, you can type "100, 200, 500,
1000, 2000" which produces the display as shown in
Figure 6.14 on page 56 . You can also
type in non‐sequential values, such as "100, 1000, 200, 2000, 500" and the steps will be
executed as entered.
To delete a range, click on the small arrow to the right of the heading, and un‐click the
Enable Range box, or simply change the setting by moving the slider or clicking the + or ‐
button and the range will be removed.