Teledyne LeCroy Merlin Mobile - Users Manual - Manual (Page 72)

64
Merlin Mobile User’s Manual CATC SW Version 2.0
specified in the 'inquiry' page of the Recording Options. The recorded traffic
would consist the transmitted packets as well as the responses received from
Bluetooth devices in the area.
IUT:HCI mode
Configures the system to exclusively record HCI traffic from IUTs. This
recording mode bypasses the analyzer: HCI traffic from the IUT is recorded
directly by the analyzer software without going through the analyzer. This
means that you can record HCI traffic even if the analyzer is not turned on.
To record HCI traffic, first enable the recording of HCI traffic from IUTs.
You do this in the HCI page of the Recording Options dialog. Then set the
recording mode to something other than IUT:HCI. If you want to prevent
the recording of HCI traffic from IUTs, disable it in the HCI page of the
Recording Options dialog.
6.2 Opening the Recording Options Dialog
Box
To open the Recording Options menu, click on the Tool Bar or select
Recording Options under Setup on the Menu Bar.