Teledyne LeCroy Summit T3-8 PCIe Multi-lane Protocol Analyzer User Manual - Manual (Page 30)

Teledyne LeCroy Using Probes
18 Summit T3‐8 PCI Express Multi‐Lane Protocol Analyzer User Manual
Figure 3.14: Half-size Gen2 Mid-bus Probe Cable and Header Assembly
Figure 3.15: Clock Cable
Connections Overview for Gen2 MidBus Probe
Use a 1‐pod setup.
Use the iPass Y‐cables to connect the probe data connectors on the Analyzer to the
MidBus pod(s).
On the other side of the pod, connect the MidBus probe assembly.
Connect the header on the MidBus probe assembly to the MidBus footprint on the
System Under Test (host platform or root complex under test). The following picture
shows two midbus footprints, with one connected to the MidBus probe assembly.
Figure 3.16: Connect MidBus Probe to MidBus Footprint