Vestil DGS-AG - Manual

12/7/05 Rev. 1/31/2012 09-126-120.doc
O
WNER
’
S
M
ANUAL
V ESTIL M ANUFACTURING C ORP .
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: 260-665-1339
E-mail:
[email protected] · www.vestil.com
M
ODEL
DGD-A, DGS-A, & DGS-AG
Assembly / Installation Instructions ………………..… 2
Operation Instructions ……………………….……….. 2 - 3
Routine Maintenance & Safety Checks ………………. 3
Exploded Structural Parts Drawing & BOM ………..... 4 - 6 Troubleshooting …………………………....…………. 3
Center of Gravity diagrams……………………………. 7
Safety Label Identification .............................................8
Warranty …………………………………….……..…. 9
Material handling is dangerous. To reduce the likelihood of
serious personal injury,
each person who might use or maintain this
product should:
o
Read and understand the owner’s manual before using or performing
maintenance on the drum handler.
o
Unload the handler before maintaining/servicing the handler.
o
DO NOT use the handler unless all labels shown on p. 7 are in place
and readable.
o
DO NOT use the handler if any damage or unusual movement is
observed, or if it seems to be malfunctioning. Notify your supervisor
or maintenance personnel if you notice anything out of the ordinary.
o
Always watch the drum grippers and the drum carefully while using
the drum handler.
o
Before transporting a drum, elevate the forks sufficiently to raise
the drum a few inches off of the ground. Transport the drum as
close to the ground as possible.
o
DO NOT exceed the maximum rated load of your model drum
handler. The load rating, in pounds, is shown on the machine data
plate. It indicates the net capacity of the drum handler with a
static load that is centered and evenly distributed.
o
Keep all personnel clear of the machine when it is in operation.
o Only use DGS-A and DGD-A units to lift and transport steel drums.
o
DO NOT modify the handler unless you are CERTAIN that the handler
will be safe to use afterwards. Any modification automatically voids
the limited warranty.
T O ORDER REPLACEMENT
PARTS :
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
R ECEIVING INSTRUCTIONS
It is possible that the unit could
incur damage during transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
DGS-A
Also verify that the product
and its specifications are as
ordered.
DGS-AG
DGD-A
V ESTIL M FG . C O ./T&S E QPT . C O . 1 of 9