Label #218, Fig. 7: product label placement diagram – Vestil FMDL User Manual
Page 12
08/2010
rev. 11/16/2012
FMDL manual, operation instructions.doc
Copyright 2010 Vestil Manufacturing Corp.
Page 12 of 12
2. Product labels: all labels should be readable and located as shown in FIG. 6. If a label(s) is unreadable or
missing, contact Vestil to order a replacement.
At least 1 time per month, inspect:
1. Fasteners (hardware):
Bolts, nuts, washers, pins, cotter pins;
Chain and snap hook.
2. Fork pockets: confirm that each pocket is structurally sound, uncorroded and free of rust. Do not use the lifter if
the fork pockets are structurally compromised, rusted or corroded.
3. Welds: confirm that all welds are intact.
4. Drum grippers, Eagle Beak® upper and/or lower jaw, fork pockets, and supporting frame: must be undamaged.
For example, no structural deformation, warps, or cracks.
5. Overall condition of drum lifter: the structure should be clean, square and rigid, and free of rust and corrosion.
Remove dirt and debris. Do not use the lifter if the supporting frame and/or one or both grippers are excessively
rusted or corroded.
FIG. 7: Product label placement diagram
Label #218:
Label #218