Vestil LLW-PAILD-200 - Manual

01/06 42-126-120
V ESTIL M FG . C O . 1
V ESTIL M ANUFACTURING C ORP .
2999 N. Wayne St., Angola, IN 46703
Ph: 260-665-7586 · Fax: 260-665-1339
E-mail: [email protected] · Website: www.vestil.com
M
ODEL
LLW-PAILD-200
Serial number ____________
Operation Instructions ……………………….……….. 2
Safety Label Identification ............................................ 3
Routine Maintenance & Safety Checks ….…………… 4
Structural Parts BOM ..................................…….……. 4 Structural Parts Drawing …..............................……...... 5
Troubleshooting …………………………....………….. 6
Warranty …………………………………….……..….. 6
I MPORTANT N OTES , W ARNINGS AND S AFETY I NSTRUCTIONS
Ensure that all employees understand and follow the following.
* Failure to read and understand this owner’s manual before using or
servicing the pail dumper constitutes a misuse of the product. All
persons who will use or care for this product must be familiar with this
material.
o
The pail carrier must be fully lowered before any work is performed on
the pail dumper.
o
Ensure that all information/safety/warning labels stay in place and are
legible.
o
Do not use the pail dumper if any damage or unusual noise is observed.
o
Always watch the pail and the pail carrier carefully when transporting or
dumping material.
o The pail dumper is intended for use only on compacted, improved surfaces.
♦ Do not perform any modifications to the pail dumper without the
manufacturer’s approval. Failure to receive authorization for changes to
the equipment could void the warranty.
♦ Maintenance and repairs are to be done only by personnel qualified to
perform the required work. Consideration will not be given for warranty
repair charges without prior written authorization by the manufacturer.
WHEN ORDERING
REPLACEMENT PARTS :
We take pride in using quality
parts on the equipment we
manufacture. We are not
responsible for equipment
problems resulting from the use
of unapproved replacement
parts.
To order replacement or
spare parts for this equipment,
contact the factory.
In any communication with
the factory please be prepared
to provide the machine’s serial
number, which is indicated on
the machine dataplate.
R ECEIVING INSTRUCTIONS
It is possible that this product
could incur damage during
transit.
Inspect the unit closely when
it arrives. If you see evidence
of damage or rough handling to
either the packaging or to the
product when it is being
unloaded, immediately make a
note of it on the Bill Of Lading!
It is important that you
remove the product’s packaging
upon its arrival to ensure that
there is no concealed damage
or to enable a timely claim with
the carrier for freight damage.
Also verify that the product
and its specifications are as
ordered.
O
WNER
’
S
M
ANUAL