WARN PullzAll SERVICE GUIDE 685005, 685006 & 685007 - Manual (Page 43)

986767A2.doc Page 43 of 45
3. PULLZALL TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
1.1 PullzAll does not
power in or pulls
slowly.
Battery is not fully charged.
Loose connection on Battery
or Motor Terminals.
Charge Battery
Be sure all connections are tight
and clean. Do not let bottom nut
or stud turn while tightening.
Check the speed mode
selected Change mode as required.
Battery voltage too low due
to Battery deterioration.
Worn Trigger Switch
Worn Brushes/Motor.
Poor Wiring Connections.
Check for loaded condition
whether overloaded.
Replace Battery.
Repair or Replace Switch.
Replace Motor
Check Wiring connections.
Use the unit within the
permissible load limits.
Rope is interfacing with Tie
Rod or other part of PullzAll.
Rewind Rope on Drum so that it is
level and not rubbing on other
parts of PullzAll.
Motor is hot.
Allow PullzAll Motor to cool for
at least 10 minutes between short
pulls. Increase cooling time for
heavy loads or long pulls.
1.2 Noise
Abnormally worn Bushing.
Worn or Broken Gearset.
Motor malfunctioning.
Replace PullzAll.
Replace PullzAll
Replace Motor.