AmpliVox ST3240 - Manual (Page 2)

2
Pinnacle
BATTERY INSTALLATIoN / SET-UP:
FEATURES:
install Power suPPly in all comPonenets:
ImPoRTANT! Do not mix battery types or attempt to recharge alkaline
batteries. Equipment dammage, safety hazard or fire could result.
Remove batteries if the unit is not going to be used for long periods
of time to prevent leakage.
SW225 Wireless Voice Projector:
Runs on AC power or battery power.
The battery carriage holds 10 D-cell alkaline batteries or our S1465
NiCad battery pack (requires S1460 AC adapter to recharge). Or run
on a 12 Volt DC adapter (automotive cigarette lighter plug-in, not
included).
Lapel & Headset Mic Battery Installation:
Requires one 9-Volt battery
or a 9-Volt AC adapter (not supplied). Remove battery door on back of
transmitter. insert one new 9 volt alkaline battery, observing polarity,
and replace the door.
sw225 wireless mic set uP:
The frequency appears on the back of each unit. Both transmitter and
receiver must have the same, and both units must be set to either
“A” or “B.” Note that two transmitters on the same frequency will not
work with one receiver. However two or more receivers will work with
the same transmitter. Before use, make certain you understand the
function and operation of the system.
Plug headset or lapel microphone into transmitter labled with 171,
select A or B frequency, turn power switch ON. A red light should come
on. Turn SW225 on with the main power switch. When the power switch
is in the ON position, the red light will be on. Turn wireless receiver
power switch on and select matching frequency to the mic transmitter,
either A or B. Both the microphone transmitter and the amplifier have to
be on the same frequency for the wireless mic to work proplerly. If you
9V DC ALKALINE
BATTERY
RIBBON FOR
BATTERY REMOVAL
BATTERY COVER
transmitter Battery installation
Power corD xlr caBle
The Pinnacle comes with a Gooseneck Mic that installs on the cable
mounted in the shock mount on the reading table. That cable is
prewired to the bottom of the unit where you plug in the supplied XLR
cable to the SW225.
The light is powered by an AC power adapter that is plugged into an
outlet strip mounted inside the unit on the bottom which has its plug
mounted in the bottom side of the unit. You plug in the supplied power
cord from the base of the unit to house AC.
The clock/timer is battery operated (LR44 Watch Batteries, not
included). The batteries can be replaced by pulling the clock out of the
panel. The batteries are in the back of the timer.
CLOCK/TIMER
LED LAMP
PADDED ARM REST
& PAPER STOP
ELECTRET
gOOSENECK MIC
encounter interference, switch frequencies. Rotate VOLUME control
knob on the amplifier to obtain desired loudness level throughout the
coverage area.
The microphone has an ON/OFF switch. it should always be in the OFF
position until the main power is ON and you are ready to speak.
The VHF wireless microphone system is compact, lightweight and
compatible with all AmpliVox VHF wireless systems. The wireless
mic operates in an authorized VHF band and has a useful range of
up to 200-ft. in line-of-sight applications. Each system operates on
two crystal-controlled, switch selectable frequencies for clear clean
transmission.
“A” Channel “B” Channel
T6: 171.105 MHz T7: 171.845