Control panel, Sw225 voice projector – AmpliVox ST3240 User Manual

Page 3

Advertising
background image

3

Pinnacle

CoNTRoL PANEL:

MAIN POWER SWITCH

The MAIN POWER switch is located on the control panel. Flip the rocker

switch to the ON position. The red light next to the switch will light up

showing that the power is on.
DC INPUT

Connection for an optional external power adapter.
AUX OUT

Power source for 12 to 15V DC accessories.
MASTER VOLUME

Controls the volume level of the microphones, including the wireless

microphones.
MICROPHONE INPUTS

There are three microphone inputs, which can be used simultaneously:
DYNAMIC

- for standard dynamic microphones, 1/4 in.

CONDENSER

- for electret or condenser microphones, which require

phantom power (supplied from the amplifier) 3.5 mm
WIRELESS

- accepts output from an external wireless microphone

receiver
AUXILIARY

The LINE IN provision is for connecting an external audio source such

as a CD player, tape player, MP3 player or computer sound card This

input also serves as a provision for connecting additional wireless

microphone receivers, audio mixers and other line level audio sources.
Separate VOLUME and TONE control knobs allow flexibility in controlling

the sound quality as well as balancing the auxiliary source with the

microphones.
OUTPUT

The LINE OUT provision may be used for connecting to an input on

a recording device, such as a computer sound card, MP3 recorder,

tape recorder, or similar device. The LINE OUT can also be used for a

number of other applications, such as connecting to a house system, or

connecting to one of our wireless speaker transmitters, for example.
EXTERNAL SPEAKERS

Two separately amplified speaker jacks allow you to use one or two

S1201, S1290, or any of our horn speakers for additional sound power.

Note: when using a stereo AUX source with a single speaker, only one

of the stereo channels will be heard. However, all MIC inputs are heard

equally on both channels.

BATTERY

DOOR PANEL

AMPLIFIER

CONTROL

PANEL

HANDLE

sw225 voice Projector

MAIN POWER

SWITCH

INTERNAL WIRELESS

MIC RECEIVER

MASTER VOLUME

MICROPHONE INPUTS

LINE IN

LINE OUT

**CONNECT S1670

HERE

SPEAKER JACK

SPEAKER JACK

TONE CONTROL

AUXILIARY VOLUME

POWER INPUT

AUX OUT

POWER

MICROPHONE

AUXILIARY

O

U

T

P

U

T

FREQ PWR

INTERNAL

WIRELESS

RECEIVER

ON

A B OFF ON

ON

OFF

ON

DC IN

AUX OUT

CONDENSER

WIRELESS

DYNAMIC

VOLUME

VOLUME

LINE IN

TONE

SPEAKERS

LINE OUT

L

R

2

3

1

MADE IN USA

1-800-267-5486 WWW.AMPLI.COM

A

M

P

L

I

V

O

X

EXTEND YOUR

VOICE WITH

PORTABLE

SOUND

SYSTEMS

s

w

2

2

5

RF INTERFERENCE

Please note that wireless frequencies are shared with other radio

services. According to the Federal Communications Commission

regulations, “Wireless microphone operations are unprotected

from interference from other licensed operations in the band. If any

interference is received by any Government or non-Government

operation, the wireless microphone must cease operation…” If you need

assistance with operation of frequency selection, please contact your

dealer or AmpliVox. Additionally There are models available for use in

Canada.
POWER SOURCE

The transmitter and receiver are each operated by a 9V alkaline battery.

Before use, install a battery as shown. Make certain the battery is fully

seated in its compartment so the cover slides in place easily. Battery life

with alkaline batteries is approximately 8 hours of operating time. The

receiver also features an external jack for connecting a 9V DC power

supply (not included).

Advertising
This manual is related to the following products: