Warner Electric PB-650 Pin Drive - Manual (Page 4)

4 Warner Electric • 800-825-9050 819-0485
Armature
Armature
Boss
Straight
Spring
Armature
Hub
Detent
Spring
Retainer
Conical
Spring
Drive Pin
Figure 4
The assembly procedure for the autogap
accessory is as follows:
Step 1
Place straight springs over armature bosses on
back side of armature. (Figure 5)
Figure 5
Step 2
Place armature hub over straight springs.
Straight springs must fit into
grooves in armature hub. (Figure 6)
Step 3
Compress conical spring against retainer ring by
sliding detent spring towards head of pin. (All 3
pins) (Figure 7)
Figure 7
Figure 6