Warner Electric Advanced Technology Tension Clutches - Manual (Page 9)

9
Warner Electric • 800-234-3369 819-0339
11. Remove the screws which retain the friction disc
segments. (See Figure 27)
12. Lift the friction disc segments off the rotor. (Item
10) (See Figure 28)
13. Clean all foreign matter from rotor mounting sur-
face. Install the new friction disc segments (Item
10-1) with new screws included with the kit. (See
Figure 29)
Note: Use only the screws included with the kit
as any others may damage the clutch.
Apply a drop of Loctite grade AA or equivalent to
each screw prior to installation. Tighten each
screw to 18-22 in. lb. torque. (See Figure 30)
14. Remove the snap ring (Item 1) from the armature
hub assembly. (See Figure 31)
When installing or removing
this or other retaining rings, be sure to hold
the ring with one hand so it will not spring
away, endangering personnel and property
should the pliers lose their grip on the ring.
Safety glasses should always be worn when
installing or removing retain
ing rings.
Figure 27
Figure 28
Figure 29
Figure 30
Figure 31