Waterstone PREP FAUCETS 4900 - Manual (Page 2)

A
B
D
F
E
C
COUNTER
OR SINK
1. 2. 3. 4.
Slide washer and thread the
clamp nut onto threaded
shroud. Tighten nut snug to
underside of sink or counter.
Turn faucet to the desired
handle position. Securely
tighten clamp screws (F).
FAUCET INSTALLATION
Remove clamp nut (A) and
washer (B) from threaded
shroud (C).
Fit flexible hoses (D) and rigid
sidespray tube (E) through hole
on counter or sink. (No plumbers
putty is required. O-ring seals
base).
1 2 3 4
Turn off water supply. Observe all local
plumbing codes.
Inspect waste and water
supplies for signs of damage.
Replace as necessary.
DO NOT use petroleum
based products on this
faucet.
REQUIRED TOOLS: PARTS INCLUDED:
2. Phillips Screwdriver 1. Adjustable Wrench
BEFORE YOU BEGIN YOUR INSTALLATION:
I N S T A L L A T I O N G U I D E
HK-THC-XX*
TRADITIONAL HANDLE CAP KIT
HK-USM1250
UNDER SINK MOUNTING HARDWARE KIT (1-1/4”)
*XX represents finish