Waterstone PREP FAUCETS 4900 - Manual (Page 3)

RED FOR HOT
BLUE FOR COLD
H C H C
COMPASS H/C COMPASS C/H FINISH MATCH
COUNTER
OR SINK
E
F
G A
C
B
D
1. 2. 3. 4.
4. Connect and tighten end
of sidespray hose to sidespray
hose tube. 3. Remove hose cap (E) from
end of sidespray hose tube (F)
on faucet (G).
CONNECTING OPTIONAL SIDE SPRAY
Waterstone faucets are designed for 3 different faucet positions. Handle
on left, front and right. Your faucet is configured for the most common
installation (see below). To reverse this and have the handle positioned on
the left, connect the hose for cold water to the hot supply and the hose for
hot water to the cold supply. This will maintain the relationship of pulling
the handle for hot water or pushing for cold water.
HANDLE ON LEFT HANDLE IN FRONT HANDLE ON RIGHT
ORIGINAL FACTORY POSITION
MAY HIT BACKSPLASH
NEW ADJUSTED POSITION
CLEARS BACKSPLASH
H C
A
B
C D
A B E
E
G
C D F
F
1. Before connecting supply hoses,
flush supply stops to clear any
debris. Place a bucket underneath
stops and run water for 5 to 10
seconds. Turn water off.
2. Carefully position hot and cold
supplies so they will not interfere
with other hoses.
3. Connect supply hoses (A) to
supply stops (B). DO NOT use teflon
tape or plumbers putty. Turn water
back on and check for leaks.
CONNECTING SUPPLY HOSES HANDLE POSITION
OPTIONAL DECORATIVE CAPS
(TRADITIONAL ONLY - 3 INCLUDED)
OPTIONAL HOT COLD INDICATOR RING
(CONTEMPORARY ONLY)
1. To remove, place a small standard screwdriver in
the slot at the bottom of metal ring that surrounds
the handle caps. Gently pry the cap from faucet
handle.
2. To replace, position cap and snap in with thumb.
1. To reverse, or remove Hot and Cold Indicator
Ring, unscrew the metal cap, remove ring and flip.
2. Slide ring back onto handle and screw metal
cap back on.
A
B
1. Insert side spray base (A) into
side spray hole on your sink or
counter. No plumbers putty is
required. O-ring seals base. Slide
washer (B), thread attaching nut
(C) and securely tighten.
2. Slide sidespray hose (D)
through side spray base.