White’s Electronics TDI - Manual (Page 9)

PulseScan TDI Owner’s Guide 9
) Connect the battery pack to the charger and plug the
charger into the A.C. outlet.
) The light in the charger will flash RED-GREEN-RED-
GREEN. This is a self check that indicates the charger is
operating correctly.
) The RED light then comes on to indicate the battery is
charging.
4) When the battery reaches full charge, a minimum of seven
hours, the light will turn GREEN indicating that the battery is
ready to use.
5) If the battery is left connected the light will start to cycle
between RED and GREEN. Unplug the charger and dis-
connect the battery.
6) Only use the charger indoors. It is not weatherproof.
7) Do not cover the charger.
8) Do not use the charger in an ambient temperature greater
than 140 degrees Fahrenheit or 40 degrees Celsius.
9) Remove the charger from the AC outlet before
disconnecting battery.
0) Charger or battery may get very warm during charging.
This is normal.
If the battery has not been used for a long period of time, it is a good idea to
recharge before use in the detector.
To recharge the battery: