WolfVision VZ-5 - Manual (Page 4)

Setting up
Please note:
Shooting area on
the working surface:
Eliminating reflections
In order to eliminate reflections
(on high gloss photographs etc.)
just turn the light backwards
slightly.
Please note that reflections can
also be caused by the room light.
to infinity
1. Loosen the knurled wheel (8) and pull the arm upwards
(Do not pull up on the light unit or camera!)
3. Connect the power adaptor to the DC-input (14) and plug it in
4. Connect a TV-monitor, a video projector or a video recorder to
the video output (12) or the Y/C-output (13)
5. Switch on the camera with the power switch (5)
White balance:
Please note that the white balance adjustment may not be correct, when switching on the unit.
In this case just move any object in the picture. Then it will work correctly.
2. Turn the video camera head (1) and point it at the working surface
The picture quality is much better if you use the Y/C
(S-VHS) output (13) rather then the composite video output
(12). Especially with typed material in black and white.
When using the composite video output please make sure that
a dedicated video cable (75
with RCA plugs is used, and
not an audio cable with RCA plugs !!!
W)
Shooting area outside
of the working surface:
Close-up adaptor lens
For shooting an object outside the working surface,
in a further distance to the unit, the close up lens (7)
has to be adjusted.
In this case just pull the lens away from the main
optic of the camera until it reaches the locked position.
It is impossible to remove the lens completely from
the unit, therefore it can not get lost.
Before turning back the camera into the standard
working position, push the close up lens back in
Turning the light backwards
In order to enable recordings with
illumination outside of the working
surface, the light of the VZ-5b can
be horizontally turned an angle of
up to 240 degrees.