WolfVision VZ-8 - Manual (Page 3)

Connectors (3):
1 Camera head
2 Light
3 Connectors (on the back
as shown below)
4 Working surface
5 Power on/off key
6 Light key (Also works as White
Balance key if pressed for 3
seconds - see page 7)
7 Close up lens for camera
8 Pull ring
9 Auto focus on/off key
(a light above this key shows
that the auto focus is on)
10 Zoom keys
7
9
10
8
3
5
6
2 2 1 1
1 1
ENGLISH
4
Setting up
1. Pull the arm upwards using the special pull ring (#8)
3. Connect the power adaptor to the DC-input (#18).
4. Connect your output unit (projector, monitor, video conferencing
unit etc.) to the appropriate output of the Visualier (#12, #13, #14,
#15 or #16).
5. Switch on the Visualizer with the power switch (#5)
2. Turn the camera head (#1) and point it at the working surface
IMPORTANT:
For choosing the right output please read the detailled
description on page 5!
Power-on preset:
The power-on preset is automatically activated when switching on the unit. The settings are:
Zoom size approx. 20 x 15 cm (A5), Autofocus on, Autoiris on.
11 External input for Computers (see page 9)
13 RGBHV output (switchable)
15 PAL/NTSC Composite video output
17 Serial control input RS232 (see page 10)
19 DC-output for lightbox 12 DVI output (see page 10)
14 PAL/NTSC Y/C (S-Video) output
16 USB-port (see page 8)
18 Power connection 12V
3
POWER LB Y/C VIDEO RS 232
7
SVGA/XGA/SXGA EXTERN IN DVI USB
11 12 13 14 15 16 17 18 19