AT&T Spirit Communications System - Manual (Page 34)

SpeedCall
32
Personal SpeedCall (308/616 System)
■ Storing Numbers
Plan the numbers you want to store in your Personal SpeedCall memory. These numbers are
available only at your telephone. You may store up to 16 numbers in your Personal SpeedCall
memory. A directory is provided on the Reference Card so that you may list the stored numbers.
Label the auto-dial buttons on 24-button telephones.
6-Button Telephone: ● Press INTERCOM. ● Lift receiver (or press SPEAKER).
● Dial number. ● Press MEMORY. ● Dial two-digit code (10 through 25).
● Dial ✱ 0 (zero).
To store another number, ● Dial number. ● Press MEMORY. ● Dial two-digit code. When you are
finished storing numbers, ●
Hang up receiver (or press SPEAKER).
24-Button Telephone: ● Press INTERCOM. ● Lift receiver (or press SPEAKER). ● Dial ✱ 0 (zero).
●
Dial number.
●
Press auto-dial button where you want to store number.
To store another number, ● Dial number. ● Press auto-dial button. When you are finished storing
numbers, ● Hang up receiver (or press SPEAKER).
If you make an error when entering a number, press the INTERCOM button with the indicator light
ON and enter the number again. To store Personal SpeedCall at telephone 10, the
administration switch on the controller must be in the OFF position. If you hear three short
beeps after you dial
✱ 0 (zero), the administration switch is ON and should be turned OFF.