XLT XD-9006B - Manual (Page 21)

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
21
Temperature Control Programming Procedure
OVEN SERVICE PROCEDURES
Read the entire instruction before programming.
TIP
Configuration Button Functions
<FUNC> =The new setting of the selected parameter is stored and the
display advances to the next parameter. This is required be
tween each parameter.
UP= Increases the setting of the selected parameter.
DOWN=Decrease the setting of the selected parameter.
1. Open V101 switch for Basic/Advanced Configuration (Figure 1)
 Remove instrument from its case
 Open switch V101
 Verify that jumper J106, is configured as shown
 Re-insert the instrument back in its case
2. Basic Configurations
 Using the configuration buttons, scroll through parameter codes,
changing them to match (Table 1)
 After P17 _._._._. Will appear
 Using the configuration buttons scroll to 262 and press <FUNC>
to enter Advanced Configurations
3. Advanced Configuration Procedure
 Using the configuration buttons scroll through parameter codes
changing them to match (Table 2)
4. Close V101 switch after Basic/Advanced Configuration (Figure 1)
 Remove instrument from its case
 Close Switch V101
 Re-insert the instrument back in its case
5. Operating Parameters Procedure (Table 3)
 On the first pass through change nnn to 3111 to unlock the ad
vanced configuration
 Scroll through the parameter codes again and change the nnn to
5 this locks the advanced configuration
 Scroll through the parameter codes again and verify nnn in ON
Ser1 OFF
P1 5˚C/22˚F
P3 0
P4 315˚C/600˚F
P5 reU
P6 4-20
P9 AL1.P
P10 H.A.
P11 nonE
P16 0
P17 SFtA
P18 norL
P19 norL
P24 reU
P25 OFF
P28 0
P29 0n
P30 0
P34 OFF
P36 tn.30
P37 0
P39 n0FL
P41 P.I.d.
P42 10.0
P43 Fn.SP
P44 0
SP 260°C/500°F
SP2 0
nnn 3111/OFF
AL1 315°C/600°F
HSA1 0.1
Pb 5.0
ti 5.00
td 0.00
1P 30.0
rL 204°C/400°F
rH 310˚C/590°F
Grd1 InF
Grd2 InF
OLH 100.00
toL InF
rnP InF
Table 3
Table 1
Table 2