IEI Integration ICE-945GSE v1.11 - Manual (Page 54)

ICE-945GSE COM Express Type 2 Module
Page 42
5.4.2 BIOS Selection
Jumper Label: SW2
Jumper Type: 4-in-1 switch
Jumper Settings: See Table 5-3
Jumper Location: See Figure 5–2
This jumper selects which BIOS to use. There is a BIOS included on the ICE-945GSE, but
a BIOS connected to the LPC or PCI bus can be used instead. The clear CMOS jumper
settings are shown in Table 5-3.
1 2 3 4 Description
OFF ON OFF OFF SPI
ON OFF OFF OFF LPC
OFF OFF OFF OFF PCI
Table 5-3: BIOS Selection
5.5 Mounting the ICE-945GSE
WARNING!
Never run the embedded module without the heat sink. The
heatspreader plate shipped with the ICE-945GSE acts as a thermal
interface between the module and the heat sink. The heat sink must be
installed on the heatspreader plate to maintain proper operating
temperatures. Make sure to maintain the heatspreader plate
temperature under 60
°C in operation.