IEI Integration eKINO-945GSE v1.01 - Manual (Page 95)

eKINO-945GSE Motherboard
Page 79
Figure 5-7: SATA Power Drive Connection
5.9.3 Dual RS-232 Cable with Slot Bracket
The dual RS-232 cable slot connector consists of two connectors attached to two
independent cables. Each cable is then attached to a D-sub 9 male connector that is
mounted onto a slot. To install the dual RS-232 cable, please follow the steps below.
Step 5: Locate the connectors. The locations of the RS-232 connectors are shown in
Chapter 3.
Step 6: Insert the cable connectors. Insert one connector into each serial port box
headers. See Figure 5-8. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.