IEI Integration KINO-AH612 - Manual (Page 64)

KINO-AH612
Page 53
Step 2: Align the DVI-I connector. Align the male DVI-I connector on the digital display
device cable with the female DVI-I connector on the external peripheral
interface.
Step 3: Insert the DVI-I connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the KINO-AH612. See Figure 4-14.
Figure 4-14: DVI Connector
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.6.3 LAN Connection
There are two external RJ-45 LAN connectors. The RJ-45 connector enables connection
to an external network. To connect a LAN cable with an RJ-45 connector, please follow
the instructions below.
Step 1: Locate the RJ-45 connectors. The location of the LAN connectors is shown in