IEI Integration IMB-Q354 v1.00 - Manual (Page 128)

IMB-Q354 uATX Motherboard
Page 106
Figure 5-21: Serial Device Connector
Step 3: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
5.8.6 USB Device Connection
There are two external USB 2.0 connectors. Both connectors are perpendicular to the
IMB-Q354. To connect a USB 2.0 or USB 1.1 device, please follow the instructions below.
Step 1: Located the USB connectors. The locations of the USB connectors are shown
in Chapter 4.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the IMB-Q354. See Figure 5-22.