IEI Integration IMB-Q870-i2 - Manual (Page 79)

IMB-Q870-i2 microATX Motherboard
Page 63
Step 5: Removing the iRIS-2400 module. To remove the iRIS-2400 module, push both
handles outward. The module is ejected by a mechanism in the socket. Step 0:
NOTE:
After installing the iRIS-2400 module, use LAN2 port to establish a
network connection. Please refer to Section 4.7 for IPMI setup
procedures.
4.3 System Configuration
The system configuration is controlled by buttons, switches and BIOS options. The system
configuration must be performed before installation.
4.3.1 AT/ATX Power Mode Setting
The AT and ATX power mode selection is made through the AT/ATX power mode switch
which is shown in Figure 4-9.
Figure 4-9: AT/ATX Power Mode Switch Location