IEI Integration IMBA-Q670 v1.02 - Manual (Page 80)

IMBA-Q670 ATX Motherboard
Page 64
Step 3: Insert the DVI-I connector . Once the connectors are properly aligned with the
male connector, insert the male connector from the digital display device into the
female connector on the IMBA-Q670. See Figure 4-14.
Figure 4-14: DVI Connector
Step 4: Secure the connector. Secure the DVI-I connector from the digital display
device to the external interface by tightening the two retention screws on either
side of the connector. Step 0:
4.5.3 HDMI Connection
The HDMI connector transmits a digital signal to compatible HDMI display devices such
as a TV or computer screen. To connect the HDMI cable to the IMBA-Q670, follow the
steps below.
Step 1: Locate the HDMI connector. The location is shown in a previous section.
Step 2: Align the connector. Align the HDMI connector with the HDMI port. Make sure
the orientation of the connector is correct