4 internal peripheral device connections, 1 sata drive connection, Nternal – IEI Integration IMBA-Q670 v2.10 User Manual
Page 76: Eripheral, Evice, Onnections
Advertising
IMBA-Q670 ATX Motherboard
Page 60
Figure 4-10: Wake-on LAN Connector Pinout Locations
4.4 Internal Peripheral Device Connections
This section outlines the installation of peripheral devices to the onboard connectors.
4.4.1 SATA Drive Connection
The IMBA-Q670 is shipped with four SATA drive cables. To connect the SATA drives to
the connectors, please follow the steps below.
Step 1:
Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2:
Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the on-board SATA drive
connector. See Figure 4-11.
Advertising