IEI Integration NANO-9453 v1.0 - Manual (Page 148)

NANO-9453 EPIC Motherboard
Page 130
Remote Access [Disabled]
Use the Remote Access option to enable or disable access to the remote functionalities
of the system.
Disabled D EFAULT Remote access is disabled.
Enabled Remote access configuration options shown below
appear:
Serial Port Number
Serial Port Mode
Flow Control
Redirection after BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
These configuration options are discussed below.
Serial Port Number [COM1]
Use the Serial Port Number option allows to select the serial port used for remote
access.
COM1 D EFAULT System is remotely accessed through COM1
COM2 System is remotely accessed through COM2
COM3 System is remotely accessed through COM3
COM4 System is remotely accessed through COM4
NOTE: Make sure the selected COM port is enabled through the Super I/O configuration
menu.