IEI Integration WAFER-945GSE v1.04 - Manual (Page 91)

WAFER-945GSE 3.5” Motherboard
Page 71
AT Power Select Description
Short 2 – 3 Use AT power Default
OFF Use ATX power
Table 5-2: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in
785H
Figure 5-4 below.
Figure 5-4: AT Power Select Jumper Location
5.5.2 CF Card Setup
Jumper Label: JCF1
Jumper Type: 2-pin header
Jumper Settings: See
786H
Table 5-3
Jumper Location: See
787H
Figure 5-5
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in
788H
Table 5-3.
CF Card Setup Description
OFF Slave Default
Short 1-2 Master
Table 5-3: CF Card Setup Jumper Settings
The CF Card Setup jumper location is shown in
789H
Figure 5-5.