IEI Integration WAFER-945GSE v1.04 - Manual (Page 99)

WAFER-945GSE 3.5” Motherboard
Page 79
4-COM port kit
5.7.2 SATA Drive Connection
The WAFER-945GSE is shipped with two SATA drive cables and one SATA drive power
cable. To connect the SATA drives to the connectors, please follow the steps below.
Step 1: Locate the connectors. The locations of the SATA drive connectors are shown
in Chapter 3.
Step 2: Insert the cable connector. Press the clip on the connector at the end of the
SATA cable and insert the cable connector into the onboard SATA drive
connector. See
852H807H
Figure 5-10.
Figure 5-10: SATA Drive Cable Connection
Step 3: Connect the cable to the SATA disk. Connect the connector on the other end
of the cable to the connector at the back of the SATA drive. See
853H808H
Figure 5-11.