IEI Integration EBC-2100 - Manual (Page 2)

EBC-2100
IEI Technology Corp. Page 3
Optional Peripherals
A.1 Optional Socket type CPU Heatsink Module (P/N: 34000-000060-RS)
AL+CU Heatsink with screws
A.2 Optional Cooling Fan Module (P/N: 19100-000027-RS)
40x40x10mm, +12V ball bearing Fan; 3 Pin; 6000RPM with screws
A.3 Optional IDE cable (P/N: 32200-000037-RS)
44pin IDE cable for 2.5” HDD
A.1 A.2 A.3
Recommendation of System cooling Components
□ recommended ■ must-have
Board Model Code CPU Board Companion
Heatsink
Heatsink
34000-000060-RS
System fan
19100-000027-RS
NANO-7240-400
-R10
ULV Intel Celeron
400MHz
■ □
NANO-7270G-R11 Socket 479 base
Pentium M/ Celeron M
CPU up to 1.8GHz #1
■ ■
NANO-7270-600-R11 ■ □
NANO-7270-600Z-R11
ULV Intel Celeron M
600MHz ■
#1 Operation Temperature: 0℃~ 40℃
Installing NANO-7270G-R11 with Pentium M 2.0GHz CPU into
EBC-2100 is not recommended due to thermal issue.
IEI Technology Corp.
Hardware Installation
The following procedures demonstrate the installation of EBC-2100. Please read
the precautions carefully before installing it.
Precautions
1. Always disconnect the unit from the power outlet whenever installing
or fixing a component inside the chassis.
2. If possible, always wear a grounded wrist strap when installing or
fixing a component inside the chassis.
3. Hold electronic circuit boards (EPIC-NANO board) by the edges only.
Do not touch the components on the board unless it is necessary.
4. Use the correct screws and never overly tighten them.
5. Keep the whole set original package in case the unit has to be
returned.
Step 1
Remove eight screws from the cover by screwdrivers .
Step 2
Remove the plastic shield inside the chassis.
Step 3