IEI Integration PPC-37xx-N270 v2.20 - Manual (Page 55)

PPC-37xx-N270 Panel PC
Page 41
AT Power Select Description
Short 1 – 2 Use AT power Default
Open Use ATX power
Table 4-3: AT Power Select Jumper Settings
The location of the AT Power Select jumper is shown in Figure 4-15 below.
Figure 4-15: AT Power Select Jumper Location
4.10.4 CF Card Setup
Jumper Label: JCF1
Jumper Type:
2-pin header
Jumper Settings: See Table 4-4
Jumper Location: See Figure 4-16
The CF Card Setup jumper sets the CF Type I card or CF Type II cards as either the slave
device or the master device. CF Card Setup jumper settings are shown in Table 4-4.
CF Card Setup Description
Open Slave Default
Closed Master
Table 4-4: CF Card Setup Jumper Settings