IEI Integration AFL-4 series-N270 v2.11 - Manual (Page 45)

AFL-4 Series-N270 User Manual
Page 45
4.5 Removing the Rear Panel
To access the AFL-4 Series-N270 internally the rear panel must be removed. To remove
the rear panel, please follow the steps below.
Step 1: Place the AFL-4 Series-N270 face down on a flat surface.
Step 2: Remove the retention screws (Figure 4-1).
Figure 4-1: Back Cover Retention Screws
Step 3: Lift the cover off and pull down the cover a bit to make it possible to lift the cover
further more after removing the retention screws. More strength is required to
separate the cover from the chassis. Step 0:
4.6 CF Card Installation
The AFL-4 Series-N270 has one CF Type II slot inside the rear panel. The slot can be
accessed without removing the back cover. To install the CF card, follow the instructions
below.