IEI Integration AFL-W19A_W19B_17D_W15A-N270 v2.20 - Manual (Page 42)

AFL-W19A/W19B/17D/W15A-N270 Panel PC
Page 31
To install the AFL-W19A/W19B/17D/W15A-N270 on the arm, follow the directions below.
NOTE:
Make sure the arm supports standard VESA mounting. The
AFL-W19A/W19B/17D/W15A-N270 uses a VESA mounting to attach
to the arm.
Step 1: The arm is purchased separately. Follow the instructions in the arm's user
manual to securely attach the arm to the wall.
Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat panel
PC onto the interface pad of the mounting arm.
Step 3: Align the retention screw holes on the mounting arm interface with those in the
flat panel PC. The arm mount retention screw holes are shown in Figure 2-19.
Figure 2-19: Arm Mounting Retention Screw Holes
Step 4: Secure the flat panel PC to the interface pad by inserting four retention screws
through the bottom of the mounting arm interface pad and into the flat panel PC.
Step 0: