3 stand mounting, 4 arm mounting, Figure 5-20: mounting screw location – IEI Integration AFL2-17A-H61 v1.11 User Manual
Page 83
AFL2-17A/AB-H61
P a g e 64
5.13.3 S ta n d Mo u n tin g
To mount the AFL2-17A/AB-H61 using the stand mounting kit, please follow the steps
below.
S te p 1:
Locate the screw holes on the rear of the AFL2-17A/AB-H61. This is where the
bracket will be attached. (Figure 5-20)
Figure 5-20: Mounting screw location
S te p 2:
Align the bracket with the screw holes.
S te p 3:
To secure the bracket to the AFL2-17A/AB-H61, insert the retention screws into
the screw holes and tighten them.
S te p 0:
5.13.4 Arm Mo u n tin g
The AFL2-17A/AB-H61 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 100mm interface pad. To mount the AFL2-17A/AB-H61
on an arm, please follow the steps below.
S te p 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.