2 unpacking procedure – IEI Integration LKM_Series User Manual
Page 41
LKM Series Console Drawer
3.2.2 Unpacking Procedure
To unpack the LKM series console drawer, follow the steps below:
WARNING:
The LCD screen has a protective plastic cover stuck to the screen. Remove
the plastic cover only after the LKM series console drawer has been
properly installed. This ensures the screen is protected during the
installation process.
Step 1:
Use a box cutter, a knife or a sharp pair of scissors to cut the tape that seals the
top side of the external (second) box.
Step 2:
Open the external (second) box.
Step 3:
Use a box cutter, a knife or a sharp pair of scissors to cut the tape that seals the
top side of the internal (first) box.
Step 4:
Lift the console drawer out of the boxes.
Step 5:
Remove both polystyrene ends, one from each side.
Step 6:
Pull the plastic cover off the console drawer.
Step 7:
Make sure all the components listed in the packing list are present.
Step 0:
Page 27