IEI Integration ICECARE 7 - Manual (Page 44)

ICECARE-07 Mobile Field Assistant
Page 33
Step 1: Insert the serial connector . Insert the DB-9 connector of a serial device into
the DB-9 connector of the docking cradle. See
44
Figure 3-23 .
Figure 3-23: Serial Device Connector
Step 2: Secure the connector . Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
Step 0:
The RS-232 serial port pinouts are shown in the following table.
Pin Description Pin Description
1 DCD 6 DSR
2 RX 7 RTS
3 TX 8 CTS
4 DTR 9 RI
5 GND
Table 3-1: RS-232 Serial Port Pinouts
Figure 3-24: Serial Port Pinouts