IEI Integration RACK-305G - Manual (Page 4)

RACK-305G QIG IEI Technology Corp. Page 4
STEP 4: Install the Power Supply unit (PSU)
Once the top cover and hold-down clamp have been removed, the PSU must be installed. Compatible IEI PSUs are listed in the table below.
Output Range
Model No. Input Type Watt
+3.3V +5V +12V1 +12V2 -5V -12V +5Vsb
ACE-940AP-RS AC AT 390W N/A 40A 15A N/A 0.3A 0.8A N/A
ACE-832AP-RS AC ATX 300W 28A 30A 15A N/A 0.3A 0.8A 2A
ACE-841AP-S-RS AC ATX 400W 28A 33A 20A N/A 0.5A 1A 2A
ACE-850AP-RS AC ATX 500W 27A 29A 18A 18A 0.3A 0.8A 2A
Table 2: Compatible IEI PSUs.
The PSU is installed at the rear of the chassis and secured to the
chassis with six retention screws. To install the PSU, please follow
the steps below.
Step 1: Correctly position the PSU at the rear of the chassis
making sure that the power switch and the cable
socket both face outwards.
Step 2: Once the PSU has been correctly positioned, secure
the PSU to the chassis by inserting two retention
screws through the side internally, and four retention
screws through the rear of the chassis.
Figure 6: Insert Internal PSU Retention Screws
Figure 7: Insert PSU Retention Screws.
STEP 5: BACKPLANE INSTALLATION
The IEI backplanes listed below are compatible with the RACK-305G
chassis.
Model No. SBC Type PCI ISA
PSU
Connector
BP-14S-RS ISA N/A 14 AT
PCI-13SD-RS PCIMG 1.0 3+4 3+3 AT/ATX
PCI-14S2-RS PCIMG 1.0 4 8 AT/ATX
PCI-14S3-RS PCIMG 1.0 4 9 AT/ATX
PX-14S3-RS PCIMG 1.0 12 2 AT/ATX
PX-14S5-RS PCIMG 1.0 7 5 AT/ATX
PXAGP-13S3-RS PCIAGP 11 N/A AT/ATX
PE-10S PICMG 1.3 4 0 ATX
Table 3: Compatible Backplanes
To install the backplane please follow the instructions below.
Step 1: Insert the nine copper pillars in the predrilled screw
holes in the bottom of the chassis.
Figure 8: Locations of the Nine Copper Pillars
Step 2: Mount the backplane onto the copper pillars and align
the backplane mounting holes with the nine screw
holes in the copper pillars.
Step 3: Once the backplane is properly aligned with the
retention screw holes, insert nine retention screws to
secure the backplane to the chassis.