AT&T E1113B - Manual (Page 41)

38
Answering system operation
.
SETUP
3.
SETUP
- OR -
until desired feature
is heard (see list at
right).
until desired selection
is heard.
to set selection and
move to next menu
option.
to set selection and
exit menu.
2. SKIP or REPEAT
PLAY
/STOP
Changing feature options
You can change how the answering system oper-
ates. Press
SETUP repeatedly to hear each feature.
When you hear the feature you want to modify
press
SKIP or REPEAT to change the setting.
Press SETUP to set selection and move to next
menu option, or press
PLAY/
STOP to exit.
NOTES:
. The message alert tone will
beep only if all the conditions
below are met:
Answering system is on
Message alert tone setting is
on
There are new messages
2. Press and hold
SKIP or
REPEAT to increase
or decrease the remote
access code number by 0.
Feature options
(default settings underlined).
System announces: Feature description:
Select a two-digit number (0-99) for
remote access from another telephone
(page 42).
"Message alert tone,"
current setting, then
"To change the setting
press
SKIP or REPEAT;
to continue setup,
press
SETUP." Options:
on/ off
"Remote access code,"
current setting, then
"To change the setting
press
SKIP or REPEAT;
to continue setup,
press
SETUP."
Options: (select two-
digit code) 19
“Base ringer,” cur-
rent setting, then “To
change the setting
press
SKIP or REPEAT;
to continue setup,
press
SETUP.”
Options: high/ low/off
"Number of rings,"
current setting, then
"To change the setting
press
SKIP or REPEAT;
to continue setup,
press
SETUP."
Options: 2/ 4/6/toll
saver
When on, the telephone beeps every
0 seconds when there are new mes-
sages.
Choose number of rings before the sys-
tem answers a call. When toll saver is
active, the system answers after two rings
if you have new messages, and after four
rings if you have no new messages. When
retrieving messages from a long distance
call, you may disconnect your call after
three rings so that there will be no long
distance charge incurred.
Choose telephone base ringer vol-
ume to high or low level, or turn the
telephone base ringer off.
Press any base key (except RECORD, ANSWER ON and
HANDSET LOCATOR) to temporarily silence the message alert tone. If
you press and hold DELETE you will delete all old messages and the
message alert tone will be temporarily silenced. The message alert tone
will be re-activated with the next incoming message.