Lincoln Electric IM10134 COOL ARC 55 S WATER COOLER - Manual (Page 19)

D-3 MAINTENANCE D-3
Removing Coolant:
a. Drain coolant from the reservoir using clean siphon-
ing equipment
b. Coolant level should be drained below the strainerʼs
pressure fitting:
• This prevents coolant from streaming out of unit
when strainer nut is removed
SERVICE THE PUMPʼS INLET STRAINER:
a. Remove all power to the unit (115VAC and
ArcLink ®) . Place absorbent towels underneath
pump head to prevent stray coolant from wetting
coolerʼs electrical components.
b. See figure D.1. Hold pump head to apply counter-
torque when loosening strainerʼs 7/8 acorn nut. Do
not confuse with 3/4 acorn nut. Remove nut and
slide inlet strainer down and out from pump head.
c. Inspect strainer for damage or excessive clogging:
• Replace or Gently rinse strainer under running
water to thoroughly clean it.
d. Use a mirror to inspect inside of pump for contami-
nation. If hardened debris is present and interferes
with filter seating, carefully remove it with dental
pick without scratching inside of the pump. Use
care not to drop debris into pump.
e. Reinstall strainer and acorn nut, tightening with
75±15 in.-lbs. of torque.
• Hold pump head to apply counter-torque when
loosening strainers 7/8 acorn nut.
f. Wipe dry all areas wetted by coolant. Dispose of
towels in an environmentally responsible manner.
Add coolant:
a. Add 2.375 gallons of coolant, either the recommen-
dations off the water cooled accessory or if none,
see the design specification summary listed in this
manual.
ADDITIONAL SERVICE NOTES:
1. Always use a back-up wrench on pump head when
loosening or tightening pump fittings.
2. Never run the pump dry. Always use a recommend-
ed coolant, otherwise pump damage may result.
3. Flush coolant from system and replace with
fresh, recommended coolant at least once a
year. More frequent flushing may be necessary,
depending upon the userʼs particular system or
its usage, especially if it is prone to clogging
from biological growth in the coolant.
COOL ARC ® 55 S
FIGURE D.1