Lincoln Electric IM10047 RED-D-ARC GX300 - Manual (Page 12)

VEHICLE MOUNTING
Improperly mounted concentrated loads may cause
unstable vehicle handling and tires or other compo-
nents to fail.
• Only transport this Equipment on serviceable vehi-
cles which are rated and designed for such loads.
• Distribute, balance and secure loads so vehicle is
stable under conditions of use.
• Do not exceed maximum rated loads for compo-
nents such as suspension, axles and tires.
• Mount equipment base to metal bed or frame of
vehicle.
• Follow vehicle manufactureʼs instructions.
---------------------------------------------------------------------------
PRE-OPERATION ENGINE SERVICE
READ the engine operating and maintenance instruc-
tions supplied with this machine.
FUEL
USE GASOLINE FUEL ONLY
Stop fueling once the fuel gauge reads full. Do not top
off tank. Be sure to leave filler neck empty to allow
room for expansion.
• Fill the fuel tank with clean, fresh fuel. The capacity of
the fuel tank is 12 gallons (45.4 liters). When the fuel
gauge reads empty the tank contains approximately 2
gallons of reserve fuel.
NOTE: The fuel tank is mounted below the engine so a
fuel shutoff valve is not required.
--------------------------------------------------------------------------------
A-4 INSTALLATION A-4
OIL
The GX 300 is shipped with the engine crankcase filled with
high quality SAE 10W-30 oil. Check the oil level before
starting the engine. If it is not up to the full mark on the dip
stick, add oil as required. Check the oil level every four
hours of running time during the first 25 running hours.
Refer to the engine Operatorʼs Manual for specific oil recom-
mendations and break-in information. The oil change inter-
val is dependent on the quality of the oil and the operating
environment. Refer to the Engine Operatorʼs Manual for the
proper service and maintenance intervals.
ENGINE COOLING SYSTEM
Air to cool the engine is drawn in lower set of louvers on the
case back. It is important that the intake air is not restricted.
Allow a minimum clearance of 2 feet (0.6m) from the case
back to a vertical surface.
BATTERY CONNECTION
Use caution as the electrolyte is a strong acid that can
burn skin and damage eyes.
--------------------------------------------------------------------------------
The GX 300 is shipped with the negative battery cable dis-
connected. Make certain that the RUN-STOP switch is in
the STOP position. Remove the two screws from the rear
battery tray using a screwdriver or a 3/8" socket. Attach the
negative battery cable to the negative battery terminal and
tighten using a 1/2" socket or wrench.
NOTE: This machine is furnished with a wet charged bat-
tery; if unused for several months, the battery may require a
booster charge. Be careful to charge the battery with the
correct polarity.
MUFFLER OUTLET PIPE
Using the clamp provided secure the outlet pipe to the outlet
tube with the pipe positioned such that it will direct the
exhaust in the desired direction. Tighten using a 9/16" sock-
et or wrench.
SPARK ARRESTER
Some federal, state or local laws may require that gasoline
or diesel engines be equipped with exhaust spark arresters
when they are operated in certain locations where unarrest-
ed sparks may present a fire hazard. The standard muffler
included with this welder does not qualify as a spark
arrester. When required by local regulations, a suitable
spark arrester, such as the S24647 must be installed and
properly maintained.
GX 300
WARNING
WARNING
WARNING
CAUTION
• Stop engine while fueling.
• Do not smoke when fueling.
• Keep sparks and flame away from tank.
• Do not leave unattended while fueling.
• Wipe up spilled fuel and allow
fumes to clear before starting
engine.
• Do not overfill tank, fuel expansion
may cause overflow.
GASOLINE FUEL ONLY
------------------------------------------------------------------------
WARNING
GASOLINE
can cause fire
or explosion.
FULL