Axis Communications Fixed Dome Network Camera AXIS P3301-V - Manual (Page 8)

8
AXIS P3301/-V - Accessing the Camera
Note:
HTTPS (Hypertext Transfer Protocol over SSL) is a protocol used to encrypt the traffic between web browsers and servers.
The HTTPS certificate controls the encrypted exchange of information.
The default administrator user
root cannot be deleted.
If the password for root is lost or forgotten, the network camera must be reset to the factory default settings. See page
32.
Adjusting the image
Open the Live View page in the web interface and make the following
adjustments on the camera.
1. Loosen the locking screw and tilt adjustment screws.
2. Turn the lens to the desired position.
3. Gently tighten the locking screw and tilt adjustment
screws to secure the camera’s position.
4. Turn the image balance ring to set the horizontal position.
5. Open the Focus Adjustment page in the web interface
under Basic Configuration > Focus and follow the
on-screen instructions. Use the image window to adjust
the focus and zoom.
To set the focus and zoom, loosen the zoom and focus
pullers counterclockwise and rotate the rings.
Lock the focus and zoom pullers in position by rotating the
screws clockwise.
Note:
Due to the dome's tendency to refract light, the image might appear slightly out of focus once the dome has been
mounted. To compensate, focus on an object slightly closer than the intended area.
To configure the password
directly via an unencrypted
connection, enter the password here.
To create an HTTPS connection,
start by clicking this button.
Image
Focus puller
Zoom puller
balance
ring
Locking screw
screw
Tilt adjustment
(on each side)