Lincoln Electric IMt10100 WIRE FEEDER WELDER 140_180 - Manual (Page 8)

INSTALLATION
WIRE FEEDER WELDERS (140, 180 MODELS)
A-2 A-2
SELECT SUITABLE LOCATION
Locate the welder in a dry location where there is free
circulation of clean air into the louvers in the back and
out the front of the unit. A location that minimizes the
amount of smoke and dirt drawn into the rear louvers
reduces the chance of dirt accumulation that can
block air passages and cause overheating.
STACKING
WIRE FEEDER WELDER(140, 180 MODELS) cannot
be stacked.
TILTING
Each machine must be placed on a secure, level sur-
face, directly or on recommended cart. The machine
may topple over if this procedure is not followed.
Read entire installation section before starting
installation.
SAFETY PRECAUTIONS
ELECTRIC SHOCK can kill.
• Only qualified personnel should perform
this installation.
• Only personnel that have read and under-
stood the WIRE FEEDER WELDER
Operating Manual should install and oper-
ate this equipment.
• Machine must be plugged into a receptacle
which is grounded per any national, local
or other applicable electrical codes.
• The WIRE FEEDER WELDER power switch
is to be in the OFF (“O”) position when
installing work cable and gun and when
connecting power cord to input power.
WARNING